Great Plains 3S-3000 Assembly Instructions - Manual (Page 11)

2/17/2005 195-307M
Great Plains Mfg., Inc.
11 Installation Instructions
Refer to Figure 14
2. On grain-only drills, install a bearing and
flanges (4) on the left side of the center bear-
ing bracket. Use 5/16" carriage bolts, lock
washers and nuts.
Refer to Figure 15
3. Rework the clutch removed from the right-
hand drive. Disassemble the clutch adaptor
(5) and plate sprocket (6). Discard the plate
sprocket and the bolts that were holding the
adaptor on the clutch. Re-assemble the adap-
tor onto the clutch using 1/4" x 2" bolts, lock
washers and existing roll pins.
Figure 14
17094
Figure 15 17095