Great Plains NTA2000 Operator Manual - Manual (Page 22)

20 NTA 2000 148-561M 2/2/2006
Great Plains Mfg., Inc.
Unfolding the Drill
!
WARNING!
Pinch Point and Crushing Hazard. To prevent serious injury or
death. Be certain the drill is hitched securely to your tractor
drawbar and the hitch safety chain is securely attached to the
tractor before raising or unfolding the drill.
• Unfold the wings with the drill raised.
• Fold only if hydraulics are bled free of air and fully charged
with hydraulic oil.
• Keep away and keep others away when folding or unfolding
drill
Coulter Extensions
Refer to Figure 17
5. After unfolding the coulter wing extensions, secure in
place with lock links and lock pins.
Makers
Note: For drills with maker option installed.
Refer to Figure 18
6. After the drill has been unfolded lower the makers and
install the lock channels over the cylinder rod as
shown. This allows the maker cylinders to retract for
field operation without retracting all the way to trans-
port position.
19743
19744
Figure 17
Lock Link and Pin
Figure 18
Lock Channel