Great Plains 4336 DH Predelivery Manual - Manual (Page 14)

10 3323-4336DH Table of Contents Index Great Plains Manufacturing, Inc.
556-100Q Table of Contents Index 05/22/2012
3323-3326 Wing Hub and Wheel Assembly
Refer to Figure 7
Note: Remove the assembly stands from center section and
allow unit to rest on the ground in the center of work ar-
ea.
13. Set pre-assembled wing frame section on stands
that are tall enough to allow for installation of the pre-
assembled gang bars as shown. Model 3329 will be the
same as models 4330-4336, See “3329-4336 Wing” on
page 14.
Note: Be sure tab or notch of hub assembly plate is in-
stalled on top.
14. Remove the 3/4 x 3 hex bolts . Bolt the hub/spindle
assembly to walking beam assembly with the 3/4 x
3 hex bolts , secure with 3/4 lock washers and 3/4
nuts.
Note: Instal tire/wheel (11L-15, 8-ply tire/wheel assembly)
to hub assembly with 9/16 lug nuts .
15. Bolts may be tightened to specs, See “Torque Values
Chart” on page 24
Figure 7
3323-3326 Wing Hub and Wheel
41617
5
3
4
7
2
1
6
U
D
F
B
L
R
1 2
3
4
3 5
4
6
3 7