Great Plains 4000TM Operator Manual - Manual (Page 25)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 21
10/30/2012 Table of Contents Index 586-288M
Refer to Figure 17 and Refer to Figure 18
Note: Note the two different turnbuckles used. One has a
rocker between two turnbuckles and the other has just
one turnbuckle between the front and rear gang bars.
They both adjust the same way.
24. When the front gang adjusting cylinders , see “Front
Gang Angle Adjustment” on page 20, have been
adjusted and are in the full retract position the rear gang
bar
should be parallel to back frame tube.
25. If rear gang bar is not parallel to back frame tube,
remove pin from turnbuckle end and shorten turn-
buckle end by turning clevis to bring gang bar closer and
lengthen clevis to lengthen to get gang bar to retract all
the way.
26. Re-install pin when adjustment is made.
Refer to Figure 19
27. When the front and rear gangs are adjusted and gang
angle cylinders are fully retracted then the gang angle
indicator will need adjusted.
28. Remove bolt from either end of gauge link and
turn threaded end until indicator reads 0 degrees.
29. Re-install bolt to secure gauge link.
Figure 17
Rear Gang Angle Rocker
42252
7
6
8
1
6
6
7 8
Figure 18
Rear Gang Angle Straight
42860
7
6
8
7
Figure 19
Gang Angle Indicator Adjustment
42253
10
11
12
9
9 10
11 12
9