Great Plains 7560 Series VII Field Cultivator-Rigid Hitch Operator Manual - Manual (Page 25)

Great Plains Mfg., Inc. Table of Contents ►
Section 1: Assembly
2/01/2005 Series VII 7551-7560 Field Cultivator, Rigid Hitch 560-199M
23
Center Wing Stop and Outside Wing Stop Assembly
U-bolt the center wing stop (1) to the
second bar from the rear on the center frame as
shown in Figure 12. Use 5/8 x 4 x 4 1/4 u-
bolts (2) with lock washers and hex nuts.
Center the wing stop from side to side. Insert
the 1/2 x 4 1/2 transport lock quick pins (3) in
the holders on the wing stop.
Attach the center wheel alignment stub
(4) to the center of the wing stop using 1/2 x 2
1/2 x 3 1/2 u-bolts (5), lock washers and hex
nuts. U-bolt the wing wheel alignment stub (6)
to the inside wing frame using 1/2 x 3 x 5 u-
bolts (7), lock washers and hex nuts. See shank
layout for proper location for your model.
U-bolt the wing lock mount (8) on the
inside wing with 1/2 x 3 x 5 u-bolts (9). U-
bolt the wing lock “T” bracket (13) on the
outside wing with the same 1/2 x 3 x 5 u-bolt
(9). Refer to the shank layout for your
particular model for the exact location of the
wing lock mount and lock “T” bracket. Use
lock washers and hex nuts on these u-bolts.
Bolt the wing latch (10) to the wing lock
mount (8) with a 3/4 x 4 1/2 bolt (11). Slide a
3/4 flat washer (12) between the latch and the
mount on each side to take out the slop. Use a
3/4” two-way lock nut but do not torque
down. The latch must move freely.
Insert the rear stand leg (14) into the
frame mount bracket (15) and pin together
with 3/4 x 4 1/2 pin (16). U-bolt the whole
assembly to the rear bar of the center frame
with two 5/8 x 4 x 4 1/4 u-bolts (17) with lock
washers and hex nuts.
Figure 12
5/22/2008