Parking, Storage, Parking storage – Great Plains 1500TM Operator Manual User Manual
Page 29
Great Plains Manufacturing, Inc.
Operating Instructions
25
12/12/2013
586-535M
Parking
Follow these steps when parking the implement for peri-
ods of less than 36 hours. For longer periods, see Stor-
age, the next topic.
1.
Position the implement on firm, level ground.
2.
Raise implement.
Negative Tongue Weight Hazard:
If rear tow hitch is installed it is possible that the Turbo Max
can tip over backwards during hitching and unhitching result-
ing in severe injury or death.
Refer to Figure 20
3.
Remove jack from storage position and pin securely
to lifting stob on outside of implement tongue
“Hitching Turbo Max to Tractor” on page 12.
4.
If ground is soft, place a wide block or plate under the
jack to increase contact area.
5.
Un-hook electrical lines and protect with any plugs or
caps provided.
6.
Release pressure on hydraulic system, then discon-
nect hydraulic lines and pull all lines back onto imple-
ment tongue. Store hose ends in keyholes of hose
holder bracket.
7.
Disconnect the safety chain.
8.
Unhitch from tractor or leading implement.
Storage
Store the implement where children do not play. If possi-
ble, store inside for longer life.
1.
Raise implement.
2.
Perform Parking checklist above.
3.
Lubricate the implement at all points listed under
“Lubrication” on page 26.
4.
Check all bolts, pins, fittings and hoses. Tighten,
repair or replace parts as needed.
5.
Check all moving parts for wear or damage. Make
notes of any parts needing repair or replacement
before the next season.
6.
Lubricate all points listed in Maintenance to prevent
rust.
7.
Clean Turbo Max of mud, dirt, excess oil and grease.
8.
Grease exposed cylinder rods to prevent rust.
9.
Use touch-up paint to cover scratches, chips and
worn areas to prevent rust.
Figure 20
Front Jack (Parking)
42244
1
1