Great Plains P17917B Operator Manual - Manual (Page 23)

23 X-Press
Operating Instructions
4.8 Starting Settings
This page details the recommended starting settings for the X-Press. These settings can
then be used as a base for further adjustment in order to get the optimum performance
from your machine.
Disc Angle Adjustment Jacks
Front Gang Rear Gang
3 Point Linkage / DD Light Roller
The machine should be set to run level front to rear and left to right.
4.8.1 Variation of Settings
If working conditions change (for example, from dry to wet conditions) then the following
table should be consulted as a rough guide.
в
в
в в
ROLL SETTING
4. Adjustment / Operation
SPRUNG LEAF SPRUNG LEAF
 












