Great Plains 1005 Calibration Kit Assembly Instructions - Manual

© Copyright 2003 Printed
Great Plains Mfg., Inc.
Used with:
Installation Instructions
152-291M
705/1005 End Wheel No-Till Drill
Calibration Kit
• 705 End Wheel No-Till Drill
• 1005 End Wheel No-Till Drill
General Information
When you see this symbol, the subsequent instructions and
warnings are serious - follow without exception. Your life and
the lives of others depend on it!
!!
These instructions explain how to install the Cali-
bration Kit Option.
These instructions apply to:
152-289A 705 Calibration Kit
152-290A 1005 Calibration Kit
Manual Update
Refer to the 705/1005 End Wheel No-Till Drill op-
erator’s manual for detailed information on safely
operating, adjusting, troubleshooting and main-
taining the calibration kit. Refer to the parts
manual for part identification.
150-213M Operator’s Manual
150-213P Parts Manual
3/5/2003
Before You Start
Page 3 is a detailed listing of parts included in the
Calibration Kit package. Use this list to inventory
parts received.
Tools Required
• Basic hand tools
• Welder
Definitions
Right-hand and left-hand as used in this manual
are determined by facing the direction the ma-
chine will travel while in use unless otherwise
stated.
Assembly Instructions
Refer to Figure 1
1. Loosen the drive chain tensioners on both the
drive chains on the left-hand gauge wheel.
2. Rotate the left-hand gauge wheel until the roll
pin (1) on the drive sprocket is in a position to
be driven out. Drive out roll pin (1) and keep.
3. Use wire or clamp to hold the sprocket in
place. There is no need to remove drive chain
once the chain has been loosened.
4. Loosen the set screws (2) from both bearings.
5. Loosen the set screw (3) and remove the
sprocket from the end of the jackshaft (4). You
may need to remove the chain if loosening the
tensioner does not allow enough slack for re-
moval of the sprocket.
Figure 1
Jackshaft
21515