Great Plains 2525F Material Rate User Manual
Page 2
Great Plains Mfg., Inc.
03/22/2007
118-231B
©
Copyright 2007 All rights Reserved
Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the prepa-
ration of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of
the information contained herein. Great Plains Manufacturing, Inc. reserves the right to revise and improve its products as it sees fit. This publication describes the state of this
product at the time of its publication, and may not reflect the product in the future.
Great Plains Manufacturing, Incorporated Trademarks
The following are trademarks of Great Plains Mfg., Inc.: Application Systems, Ausherman, Land Pride, Great Plains
All other brands and product names are trademarks or registered trademarks of their respective holders.
Printed in the United States of America.
Table of Contents
Introduction................................................................ 1
Products Covered......................................................... 1
Document Family.......................................................... 1
Setting Planting Rate.................................................... 1
Setting Drive Type ........................................................ 2
Set Seed Rate Handle.................................................. 3
Position Seed Cup Doors ............................................. 3
Seed Cup Rate Charts............................................... 4
Reading a Seed Cup Rate Chart.................................. 4
Seed Cup Rates ........................................................... 5
Checking Seed Cup Rate........................................... 10
Calibration Equations ............................................. 10
Tire Revolutions Per Acre .......................................... 11