Side to side leveling – Great Plains 8560 FCF Operator Manual User Manual
Page 19
Advertising
Great Plains Manufacturing, Inc.
Preparation and Setup
15
11/12/2013
560-483M
Side to Side Leveling
Refer to Figure 7
12. Set the wings to match the depth of the center. This is
done by adjusting the adjustment bolt assembly
on
each wing. Start by loosening the jam nut
, then
adjust the adjustment rod
. Lengthen the adjustment
rod
(turn counter-clockwise), to run shallower,
shorten the bolt (turn clock-wise) to run deeper.
13. Tighten jam nut
, back against clevis.
Note: In some conditions the wings will need to be set slight-
ly lower than the center, as the center may tend to run
deeper behind the tractor tires.
Figure 7
Wing Depth Adjustment
4729
1
2
3
1
2
3
3
2
Advertising
This manual is related to the following products: