Great Plains UT5052 Predelivery Manual - Manual (Page 12)

576-026Q 12/31/2013
8 3030-UT5052 Great Plains Manufacturing, Inc.
Assembly
Disc or Coulter Gangs
Note: When machine is unloaded from truck, hook
machine to a tractor and be sure hose ends are
clean and hook them to tractor so machine can be
raised or lowered to ease the assembly process.
Remove wing fold pins and carefully unfold wings
to install wing gangs.See layout section for proper
location of gang assemblies. The gangs will be
marked on end blade with part number and loca-
tion. The disc or coulter gangs are installed the
same way. Coulter gangs are shown.
Refer to Figure 5
18. Remove bolts and pins from shipping locations
shown. Carefully move gang assemblies to proper
location and lower machine down until holes are
properly aligned in gang hanger
. secure front with
with 1 x 5 1/2 pins , 3/8 x 2 1/4 hex bolts and 3/8
top lock nuts.
19. Attach rear 3/4 x 2 1/2 pins , 3/4 flat washer and
1/8 x 1 1/2 cotter pins.
20. Tightened all bolts to specs, See “Torque Values
Chart” on page 13 and bend cotter pins.
1
2
3 4
5 6
Figure 5
Disc or Coulter Gangs 43189
1
3
2
1
3
4
5
6 5