Great Plains Electronic Acremeter (Danaher) Assembly Instructions - Manual

Great Plains Mfg., Inc.
Installation Instructions 1
©Copyright 2012 Printed 11/13/2012 152-314M
Electronic Acremeter
Great Plains Drills
Used with:
• Most Great Plains Drills
*
General Information
These instructions explain how to install and use an
Electronic Acremeter. This acremeter has replaced the
mechanical acremeters previously supplied, and pro-
vides more precise tallying of acres planted.
These instructions apply to an installation of:
Consult your Great Plains dealer for specific ordering
information. The meter is factory programmed for spe-
cific revolutions and units, and provides accurate and
easy-to-use readings only on a drill with matching oper-
ating characteristics.
The meter is supplied with a decal indicating the factory
configuration. Placing it on a drill for which it was not pro-
grammed will produce unsatisfactory results.
Each acremeter upgrades one drill.
Tools Required
• basic hand tools
* The electronic acremeter is compatible with all drills
having a main or transfer drive shaft with at least one 1/
2-20 tapped hole in either end of the shaft on any sec-
tion of the drill. The shaft must be before any Drive
Type, gearbox, lower, range, transmission or upper
variable sprockets, and have only fixed sprockets and
chains between the drive wheel and the shaft.
Kit Product Description
See Below ELECTRONIC ACREMETER
Figure 1
Electronic Acremeter
27378