Great Plains PT1230 AA1080 Operator Manual - Manual (Page 14)

12
Section 1 Preparation and Setup
PT1230 Pull-Type Folding Planter 401-069M-B 4/12/05
Great Plains Mfg., Inc.
Leveling Planter
During initial setup and periodically throughout the sea-
son, check that the planter runs level. When planting, the
top of the hopper support panel should be parallel to the
ground as shown in Figure 1-4.
To level the planter, the bottom of the main frame tube
must run between 20 and 22 inches above ground when
lowered into planting position. See Figure 1-4.
To obtain the correct height, reposition the planter hitch on
the tongue. The hitch can be turned over for different
heights. See Figure 1-5.
Achieving correct planter position can be difficult with
some attachment combinations, especially when planting
in hard to penetrate soils. Avoid using more attachment
down force than is required.
IMPORTANT: When hitching the planter to a different
tractor, check for a difference in drawbar heights. If
the heights are different, readjust height accordingly.
14956
15819
Figure 1-4
Leveling the Planter
Figure 1-5
Hitch Positions
Top of Hopper Support Level with Ground