Great Plains YP1625 Operator Manual - Manual (Page 103)

Great Plains Manufacturing, Inc. Hydraulic Drive Operating Instructions 99
07/09/2009 401-226M
Refer to Figure 109
15. The drive is about to operate, meaning there is a
danger of entanglement if anyone is in the drive
area.
!
WARNING
Be sure to verify that no one is near the drive area before
advancing to the next step.
Refer to Figure 110
16. Only after you have verified the drive area is clear,
press the up arrow key to initiate calibration mode. If
drive area isn’t clear, press Down arrow key to exit
calibration mode.
Refer to Figure 111
17. Continuing to verify that the drive area is clear, press
the Engage key to start drive rotation. Pressing
Function key will exit calibration mode.
Refer to Figure 112
18. While the drive is rotating, the display window shows
the time remaining and the “Out” rate.
!
CAUTION
CONTINUE TO MONITOR DRIVE AREA DURING DRIVE
ROTATION. PRESS THE ENGAGE KEY (OR OFF KEY) TO
STOP DRIVE DURING CALIBRATION
Figure 109
Cal. Mode Clear Area
22724
Figure 110
Cal. Mode Area Clear
22725
Figure 111
Cal. Mode Initiate Motion
22726
Figure 112
Cal. Mode Prompt In Motion
22783