Great Plains 3-Point No-Till Precision Seeding System User Manual
Page 2
298-284m
4/8/2004
Great Plains Mfg., Inc.
Monitor System Option
2
Assembly Instructions for 298-287A 15P 15" Row Spacing
Refer to Figure 1
1.
Attach the module mount (1) to the top drill frame using
a 3/8" x 3 3/4" bolt and 3/8" lock nut as shown.
2.
Attach the harness wire bundle (2) to the back of the
module mount (1) using cables ties (3).
3.
Secure the 12-Row module (4) to the module mount (1)
with two 1/4" x 1 1/4" bolts and two 1/4" lock nuts.
4.
Connect the wire extensions to the openers starting at
the left side of the drill in numerical order. Wire exten-
sion number 1 with first opener on the left. Continue in
the same manner until all wire extensions are connect-
ed. Fasten the harness to the frame with cable ties.
5.
Connect black and gray colored leads into the material
flow modules. Inlets are color coded. Black to black and
gray to gray.
6.
Attach sensor lead marked IN from the 12-Row har-
ness to the 30’ module extension cable. Put a cable
plug in the OUT lead of the 12-Row harness. Route the
cable along the frame and to the back of the tractor us-
ing cable ties to hold in place. Connect the end of the
30’ cable to the P1 port of the cab harness at the back
of the tractor. Put a 2-Pin cable plug in the P2 port of
the cab harness.
7.
Attach the 30’ speed sensor extension cable to the
speed sensor.
Note: For speed sensor mounting and adjustment instruc-
tions refer to page 24.
8.
Route the 30’ speed sensor extension cable along the
frame and to the back of the tractor using cable ties to
hold in place. Connect the cable to the 2-Pin sensor
plug from the cab harness.
9.
Refer to page 3 for a detailed listing of parts and sche-
matics for this particular monitor system.
Note: For console assembly, speed sensor and other sche-
matics illustrations refer to the DJ manual found in the mon-
itor system package.
20429
Figure 1