Great Plains 3-Point No-Till Precision Seeding System - Manual (Page 6)

298-284m 4/8/2004
Great Plains Mfg., Inc.
Monitor System Option 6
Assembly Instructions for 298-368A 25P 38" Twin Row Spacing
Refer to Figure 1
1. Attach the module mount (1) to the top drill frame using
a 3/8" x 3 3/4" bolt and 3/8" lock nut as shown.
2. Attach the harness wire bundle (2) to the back of the
module mount (1) using cables ties (3).
3. Secure the 16-Row module (4) to the module mount (1)
with two 1/4" x 1 1/4" bolts and two 1/4" lock nuts.
4. Attach the harness wire bundle to the back of the mod-
ule mount using cables ties. Connect the wire exten-
sions to the openers starting at the left side of the drill
in numerical order. Wire extension number 1 with first
opener on the left. Continue in the same manner until
all wire extensions are connected. Fasten the harness
to the frame with cable ties.
5. Connect black and gray colored leads into the material
flow modules. Inlets are color coded. Black to black and
gray to gray.
6. Attach sensor lead marked IN from the 16-Row har-
ness to the 30’ module extension cable. Put a cable
plug in the OUT lead of the 16-Row harness. Route the
cable along the frame and to the back of the tractor us-
ing cable ties to hold in place. Connect the end of the
30’ cable to the P1 port of the cab harness at the back
of the tractor. Put a 2-Pin cable plug in the P2 port of
the cab harness.
7. Attach the 30’ speed sensor extension cable to the
speed sensor.
Note: For speed sensor mounting and adjustment instruc-
tions refer to page 24.
8. Route the 30’ speed sensor extension cable along the
frame and to the back of the tractor using cable ties to
hold in place. Connect the cable to the 2-Pin sensor
plug from the cab harness.
9. Refer to page 7 for a detailed listing of parts and sche-
matics for this particular monitor system.
Note: For console assembly, speed sensor and other sche-
matics illustrations refer to the DJ manual found in the mon-
itor system package.
20429
Figure 1