Great Plains Reel For Rolling Harrow Manual(Series I) Assembly Instructions - Manual

586-167M
Assembly Instructions for the Reel Following the Rolling Harrow
Mount the reel arm assemblies (589-069L) to the drag frames, using the dimensions in the
layouts provided, using a 5/8x3x4 ½ u-bolt (806-183C) with a lock washer and nut. Assemble the reel
sub-assemblies to the reel tube by u-bolting the reel brackets to the correct tube with a 5/8x2 1/2x3 ¾ u-
bolt (806-182C), lock washer, and nut. If you are assembling a 10’ or 12’ reel, do not install the two
center u-bolts as you will use 5/8x4 hex bolts (802-060C), with lock washers and nuts in this location as
shown in bubble labeled double reel center mounting on parts breakdown page. Once the reels are
attached to the reel bar, bolt the reel bar to the reel arm assemblies using the dimensions provided on the
layouts. If you are bolting on a 10’ or 12’ section; by using the 5/8x4 bolts as shown in figure 5 the reel
should be in the proper location if installed correctly. If the reels between the center section and the
wing sections are closer than 5”, recheck the reel arm dimensions and adjust accordingly.
Mount the rear stand bracket (580-049H), if applicable, to the drag frame with 5/8x3x4 ½ u-
bolts, a lock washer and a nut. The rear stand leg (560-196H) should be pinned in the rear stand bracket
with a 3/4x4 ½ pin and retainer (805-081C).
Note: For Turbo-Till models 2200 and 3000 reel following rolling harrow attachment, add wing
weights by removing the bolt on end caps from the front wing gang bars and sliding in weights provided
(1/2” x 5” flat).
Page 1
10/20/2005