Great Plains YP4025A Operator Manual - Manual (Page 116)

112 YP4025A Table of Contents Index Great Plains Manufacturing, Inc.
401-627M Table of Contents Index 2013-04-24
Wing Leveling, Outboard End
Refer to Figure 136 on page 111 and Figure 138
1.
Measure from the bottom of the wing tool bar to the
ground at the outer end of each wing.
2. Compare to the measurement at the outer end of the
center tool bar, at the wing pivot location. All
measurements should be identical, and close to 26in
(66cm).
3. If measurements do not match, loosen upper gauge
wheel jam nut
, and adjust eyebolt link length with
adjuster nut .
4. If adjustments are needed on either side, re-check
the other side after each adjustment, and re-adjust it
as needed.
5. Once level, tighten the lock nut .
Figure 138
Leveling Outer Wing
29314
2
1
1
2
1