Great Plains CP1000 Predelivery Manual - Manual (Page 7)

4 CP1000 Three-Meter Drill and Hitch 148-358Q 10/16/08
Great Plains Mfg., Inc.
6. With center-pivot hitch properly secured to tractor
drawbar, remove transport lock pins located in vertical
tubes above tires and place in storage hole next to sta-
bilizer cylinder on hitch as shown in Figure 2-3.
12081
Figure 2-3
Transport Pins in Storage
7. Position the center pivot hitch in front of drill so quick-
hitch links on hitch are in line with lower hitch pins on
drill. Hydraulically retract transport-lift cylinders to po-
sition quick-hitch links slightly lower than drill hitch
pins.
8. Position quick-hitch handle to locking position as
shown in Figure 2-4. This will allow drill hitch pins to
snap into quick-hitch links and secure drill to hitch.
10747
Figure 2-4
Quick Hitch Handles in Locking Position
9. Back center-pivot hitch up to drill until hitch pins con-
tact quick hitch. Hydraulically raise hitch just until hitch
pins are securely attached inside quick-hitch links. Do
not raise drill any higher than necessary.
10. Attach slotted link from center pivot hitch (1) to top
hitch on drill. Using hitch pin (2) and bushing (3), se-
cure with clip pin (4) as shown in Figure 2-5.
17220
Figure 2-5
Top Hitch Pin and Bushing
Hydraulic Hook-up
!
WARNING!
Escaping fluid under pressure can have sufficient force to pene-
trate the skin. Check all hydraulic lines and hoses before apply-
ing pressure. Fluid escaping from a very small hole can be
almost invisible. Use paper or cardboard, not body parts, to
check for suspected leaks. If injured, seek medical assistance
from a doctor that is familiar with this kind of injury. Foreign
fluids in the tissue must be surgically removed within a few
hours or gangrene will result.
Great Plains hydraulic hoses are colour coded to help you
hook-up hoses to your tractor outlets. Hoses that go to the
same remote valve are marked with the same colour.
Hydraulic Function
Red Transport Lift Cylinders
Blue Tongue Cylinder