Great Plains Inline Ripper Hitch Parts Manual - Manual (Page 2)

© Copyright 2005 All rights Reserved
Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the
preparation of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from
the use of the information contained herein. Great Plains Manufacturing, Inc. reserves the right to revise and improve its products as it sees fit. This publication describes
the state of this product at the time of its publication, and may not reflect the product in the future.
Great Plains Manufacturing, Incorporated Trademarks
The following are trademarks of Great Plains Mfg., Inc.: Application Systems, Ausherman, Land Pride, Great Plains
All other brands and product names are trademarks or registered trademarks of their respective holders.
Printed in the United States of America.
Table of Contents
599-023P
Table of Contents
Table of Contents ➧ Part Number Index ➧
Section 1 Introduction . . . . . . . . . . . . . . . . . . . . . 1-1
General Information . . . . . . . . . . . . . . . . . . . . 1-1
Using This Manual . . . . . . . . . . . . . . . . . . . . . . 1-1
Manual Replacement Information . . . . . . . . . . 1-1
Manual Revisions . . . . . . . . . . . . . . . . . . . . . . 1-1
Touch-up Paint . . . . . . . . . . . . . . . . . . . . . . . . . 1-1
Hardware Legend . . . . . . . . . . . . . . . . . . . . . . 1-2
Replacement Hardware . . . . . . . . . . . . . . . . . . 1-2
Serial Numbers . . . . . . . . . . . . . . . . . . . . . . . . 1-2
Part Number Service Coding . . . . . . . . . . . . . . 1-2
Part Number Index . . . . . . . . . . . . . . . . . . . . . . 1-3
Section 2 Frame . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1
Tongue . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1
Section 3 Transport. . . . . . . . . . . . . . . . . . . . . . . . 3-1
Transport . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1
Spindle And Tire . . . . . . . . . . . . . . . . . . . . . . . 3-3
Section 4 Hydraulics. . . . . . . . . . . . . . . . . . . . . . . 4-1
Hydraulics . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1
Hydraulic Cylinder
(810-521C 4x16x1.38 Rod) . . . . . . . . . . . . . . . 4-3
Hydraulic Cylinder
(810-520C 3.75x16x1.38 Rod) . . . . . . . . . . . . 4-5
Section 5 Decals . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
Decals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
7/25/2005
Section 1 Introduction
599-023P