Great Plains 3-Point Drills Assembly Instructions - Manual

1
Assembly Instructions
Great Plains Mfg., Inc.
© Copyright 1996 Printed 8/29/12
Used with:
•
121-700M
3-Point
Bedded Irrigation
3-Point Drills
Before You Start
These option assembly instructions contain only information on
assembling the attachment to the main unit. A detailed Opera-
tor’s Manual was supplied with the main unit when it was pur-
chased. For more specific information on safety concerns refer to
the Operator’s Manual. Also included in the Operator’s Manual is
important information on operation, adjustment, troubleshooting,
and maintenance for this attachment (some of these sections do
not apply to all options).
A separate Parts Manual for replacement parts can be pur-
chased from your dealer. Have model and serial numbers handy
when placing an order.
Starting on page 5 is a detailed listing of parts included in these
kits. Use this list as a checklist to inventory parts received.
Assembly Instructions
Opener Mounting and Gauge Wheel Installation
Refer to Figure 1-1:
1.
Determine the row spacing of your drill: 6", 7", 7 1/2" or 10".
2. Find the layout for your drill from one of the 4 views below.
3. The centerline of the tire is determined by the “Beds” (60",
40", or 30" you are using.
4. The special bedded drop brackets are installed over each
bed as shown. If the opener lands in the bottom of the bed,
the front pivot bolt (#6 Fig: 1-5) should be installed in the bot-
tom hole. If the opener runs in the side of the bed, bolt (#6
Fig:1-5) should be installed in the middle hole.
■
When you see this symbol, the subsequent instructions
and warnings are serious - follow without exception. Your
life and the lives of others depend on it!
!!
Figure 1-1 15742