Great Plains 6328 Series VII Field Cultivator-Rigid Hitch Operator Manual - Manual (Page 15)

Great Plains Mfg., Inc. Table of Contents ►
Introduction
1/16/2009 Series VII 6113-6328 Field Cultivator, Rigid Hitch 560-202M
13
Assembly and Setup Assistance
To order additional copies of operator’s and parts
manuals, write to the following address. Include
model numbers in all correspondence.
If you do not understand any part of this manual
or have other assembly or setup questions, assis-
tance is available. Contact
Product Support
Great Plains Mfg. Inc., Service Department
PO Box 5060
Salina, KS 67402-5060
Pre-Assembly Checklist
• Before assembling, read and understand “Im-
portant Safety Information,” beginning on
page 1.
• Have at least two people on hand while as-
sembling.
• Make sure assembly area is level and free of
obstructions (preferably an open concrete ar-
ea).
• Have all major components.
• Have all fasteners and pins shipped with
Series VII Field Cultivator.
• IMPORTANT: If a pre-assembled part or fas-
tener is temporarily removed, remember
where it goes. Keep the parts separated.
• Have a copy of the parts manual on hand. If
unsure of proper placement or use of any part
or fastener, refer to the parts manual.
•
Check that all working parts are moving free-
ly, bolts are tight, and cotter pins are spread.