Great Plains 3N-3010P Assembly Instructions - Manual (Page 4)

4 3N-3010P, No-Till Flat Fold Marker Option 113-739M 5/5/06
Great Plains Mfg., Inc.
Assembly Instructions
■
Refer to Figure 5.
11. Slide the fourth-section tube (37) inside the third
section (33). The holes in the fourth section must
be to the outside of the drill and on the top and bot-
tom side as shown. Thread the jam nuts (38) on the
square-headed set screws (39). Thread the set
screws into the nuts welded to the outer end of the
third section (33). Tighten the set screws and jam
nuts.
12. Slide the blade and spindle (40) over the fourth-
section tube (37). Secure the spindle to the tube
with bolts (41), flat washers (42), lock washers (43)
and nuts (44). Tighten the two nuts.
Refer to Figure 6.
13. Mount the transport carrier (45) to the wing box
frame drive support (46) and secure it with two 1/2"
x 2 1/32" x 3 1/4" u-bolts (47), lock washers (49),
and nuts (48)..
14. Fasten the carrier to the mount using the two u-
bolts (47).Tighten the u-bolts with the lock washers
(48) and nuts (49) so that the bottom of the support
tube is about 1 1/4 inches above the frame plate.
You may need to re-adjust carrier height after as-
sembly. Refer to Transport Carrier, "Setup Adjust-
ments," page 6. To complete assembly for dual
markers, repeat steps three through twelve.
15. After all parts are in place, tighten all bolts and u-
bolts. Refer to the torque chart in your drill opera-
tor’s manual. Torque u-bolts to grade 5 values.
19175
Figure 5
Attaching Fourth Section
Figure 6
Transport Carrier Mounting
11103