Setting fertilizer drive range, Setting high range, Setting low range – Great Plains 3S-5000HDF Material Rate User Manual
Page 17: Setting high range setting low range
Great Plains Manufacturing, Inc.
Setting Fertilizer Rate
15
2012-06-04
195-325B
Setting Fertilizer Drive Range
Refer to the Fertilizer Rate Chart on page 19 to find the
correct Range sprocket size for your drill’s row spacing
and target (or adjusted) application rate.
Refer to Figure 6
Note: When re-assembling and re-mounting chains,
make sure the open ends of chain clips face away
from the direction of chain travel (shown by the gray
arrow).
Setting High Range
High Range uses the smaller 16T sprocket
already engaged by the chain, no change is necessary.
Loosen the idler sprocket
and remove chain from
driving
and range
sprockets.
2.
Open chain at removable link and remove the
16-pitch section of the chain. This section has clips
on each end. Save it for future use.
3.
Loosen the set screws
on the driving sprocket
,
and slide it on the shaft until it is in alignment with the
small 16T High Range sprocket
4.
Re-engage the idler sprocket
, allowing
1
⁄
4
inch
(6.4 mm) slack in the top chain span. Tighten set
screws
on driving sprocket
5.
If this is the final Range setting, after calibration,
repeat step 1 through step 4 for the center and right
drill sections.
Setting Low Range
Low Range uses the larger 44T sprocket
already engaged by the chain, no change is necessary.
Loosen the idler sprocket
and remove chain from
driving
and range
sprockets.
2.
Insert the saved 16-pitch section of the chain. This
section has clips on each end. Save chain section.
3.
Loosen the set screws
on the driving sprocket
,
and slide it on the shaft until it is in alignment with the
large 44T Low Range sprocket
4.
Re-engage the idler sprocket
, allowing
1
⁄
4
inch
(6.4 mm) slack in the top chain span. Tighten set
screws
on driving sprocket
5.
If this is the final Range setting, after calibration,
repeat step 1 through step 4 for the center and right
drill sections.
Figure 6
Chain Clip Orientation
26482
2
Figure 7
Fertilizer Drive Low Range
21778
4
3
1
2
5
2
3
1
2
3