Great Plains PT8030 V1013 Operator Manual - Manual (Page 33)

31
Section 3 Adjustments
PT6030 and PT8030 Pull-Type Planter 401-032M-A 10/10/12
Great Plains Mfg., Inc.
Meter Drive Alignment
Refer to Figure 3-22.
1. With the hopper in place loosen the two 5/16-inch
nuts.
2. Engage the clutch to the meter input shaft.
3. Align clutch with shaft and tighten 5/16-inch nuts as
specified on the Torque Values Chart, “Appendix,”
page 52.
Figure 3-22
Meter Drive Alignment
16870