Great Plains Rolling Harrow & Reel Manual (Series II) - Manual (Page 7)

Great Plains Mfg., Inc. Section 2: Assembly & Set-Up
10/25/2007 SeriesII 1200TT-4000TT Turbo-Till Attachments 586-216M
5
Reel Following the Rolling Harrow Assembly
Mount the reel arm assemblies (1) to the
drag frames as shown in Figure 2, using the
dimensions in the layout drawings starting on
page 7, using a 5/8 x 3 x 4 1/2 u-bolt (2) with a
lock washer and hex nut. These bolts may be
tightened at this time.
Assemble the reel sub-assemblies (3) to
the reel arm assemblies (1) with 5/8 x 2 1/2 x 3
3/4 u-bolt (4), lock washer, and hex nut The
correct reel placement are shown in the
placement drawings, starting on page 16. If
you are assembling a 10’ or 12’ reel, you will
use 5/8 x 4 hex bolts (5), with lock washers and
hex nuts in center location as shown in figure 2.
If the reels between the center section and the
wing sections are closer than 5”, recheck the
reel arm dimensions and adjust accordingly.
Figure 2