Great Plains YP1625 Installation Instructions - Manual (Page 2)

Great Plains Mfg., Inc.
2 Fan Sensor Kit
168-045M 10/09/2006
Installation
Prepare Both Sensors (all screen types)
Prepare New Sensor Assembly
Refer to Figure 1.
1. Remove the nut (and lock washer) from the new sen-
sor
➀
.
2. Insert the sensor through the new bracket
➁
from the
indented side.
3. Loosely tighten the nut and washer - some adjust-
ment is required in a later step.
Cut Old Sensor Cable
Refer to Figure 2.
4. Using wire cutters, cut the existing sensor cable
➂
near where it enters the fan screen.
An additional cut may be made later, but this first cut
provides ample reserve cable length.
Note: Cage screen assembly shown. Your implement
may have a flat screen.
Figure 1
Assemble New Sensor
25111
➀
➁
Figure 2
Cut Old Sensor Cable
25112
➂