Great Plains 6548 Series VII Field Cultivator-Floating Hitch Operator Manual - Manual (Page 17)

Great Plains Mfg., Inc. Table of Contents ►
Section 1: Assembly
1/22/2005 Series VII 6330-6548 Field Cultivator, Floating Hitch 560-205M
15
Inside Wing and Wheel Arm Assembly
Bolt the inside wing frames (1) Figure
2, to the center frame with two 1 x 6 hex bolts
(2) with nylon lock nuts (3). Draw the nuts
down tight but do not torque.
Once the wings are attached, insert the
wheel arm bracket (4) into the wing frame
hangers and secure it just as you did on the
center with 1 1/4 x 6 pins (5). Secure the pins
with 3/8 x 2 1/4 Gr.8 hex bolts (6) & top lock
nuts.
Install the wing walking beam assembly
(7) as shown in Figure 2 with the 14” spindle
(6330 & 6332) or 18” spindle (6537-6548)
toward the front and 13” spindle on the back..
Secure the pivot spindle in the sleeve with the
5/16 x 3 clevis pin (8) and 1/8 x 1 cotter. Use
anti-seize material on spindles
Bolt the 9.5L x 15, 8-ply tire (9) in
place with the 1/2 x 1 1/4 lug bolts (10). On
model 6332, bolt the 11” bolt on stub (12) to
the wing frame using 5/8 x 1 1/2 hex bolts (13),
using lock washers and hex nuts.
Figure 2