Great Plains Power Beyond - Manual (Page 19)

page 7 of 10
ba01031
1 r4
Great Plains Manufacturing reserves the right to make changes or to add improvements to this guide at any time without notice or obligation.
PB 01/03/11
These tractor models may or may not be
equipped with power beyond lines from the
factory. The part numbers given for these
models is assuming the power beyond lines
are installed. Contact an AGCO dealer if power
beyond lines are not installed.
IMPORTANT: The couplers called out in the
AGCO parts books for the case drain and load
sense connections are NOT compatible and
must be changed.
AGCO calls for using a female flat face coupler
for load sense and a standard 1/2” male coupler
for the case drain which are not compatible.
Case drain requires a 3/8” body size ISO
16028 zero pressure female flat face coupler.
Load sense requires a 1/4” body size female
coupler.
Determining Type of Fittings Needed for
8600 Series / DTB Series / MT600C Series
T
e
f
a
M
s
s
A
f
f
U
c
The couplers supplied through AGCO for motor
return and power beyond pressure are
compatible and can be used.
There are two different types of fittings used
on these models of tractors. The difference is
in the type of caps on the bulkhead fittings. One
type is ORFS (one piece), the other type is DIN.
Determine which type of caps are on the tractor
and use the correct diagram and parts listing
on the following two pages to install adaptor
fittings for case drain and load sense couplers.
DIN plug
FORFS plug
DIN Caps - see page 9 of 14 ORFS Caps - see page 8 of 14