Great Plains EWNT10 - Manual (Page 3)

Using this Manual
-2 5/3/96 Great Plains Mfg., Inc. 7’ & 10’ End Wheel No-Till Clutch Linkage 152-156M
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Using this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Section 1 Safety Rules . . . . . . . . . . . . . . . . . . . . . . . 2
Section 2 Assembly & Set-Up . . . . . . . . . . . . . . . . . 2
Torque Values Chart . . . . . . . . . . . . . . . . . . . . . . 2
Before You Start . . . . . . . . . . . . . . . . . . . . . . . . . 3
Old 7’ Clutch Linkage Disassembly . . . . . . . . . . . 3
New 7’ Clutch Linkage Assembly . . . . . . . . . . . . 4
Before You Start . . . . . . . . . . . . . . . . . . . . . . . . . 5
Old 10’ Clutch Linkage Disassembly . . . . . . . . . . 5
New 10’ Clutch Linkage Assembly . . . . . . . . . . . 6
Section 3 Parts Illustrations. . . . . . . . . . . . . . . . . . . 8
7’ Clutch Linkage Update Assembly. . . . . . . . . . . 9
10’ Clutch Linkage Update Assembly. . . . . . . . . 11
Table of Contents
This manual has been prepared to instruct you in the
safe and efficient operation of your Clutch Linkage Up-
date Kit. Read and follow all instructions and safety
precautions carefully.
The parts on your Clutch Linkage Update Kit have been
specially designed and should only be replaced with
genuine Great Plains parts. Therefore, should your
Clutch Linkage Update Kit require replacement parts go
to your Great Plains Dealer.
The right hand and left hand as used throughout this
manual is determined by facing in the direction the ma-
chine will travel when in use unless otherwise stated.
!
The SAFETY ALERT SYMBOL indicates that there is a
potential hazard to personal safety involved and extra
safety precautions must be taken. When you see this
symbol, be alert and carefully read the message that fol-
lows it. In addition to design and configuration of
equipment; hazard control and accident prevention are
dependent upon the awareness, concern, prudence and
proper training of personnel involved in the operation,
transport, maintenance and storage of equipment.
Watch for the following safety notations throughout your
Operators Manual:
!
DANGER!
Indicates an imminently hazardous situation which, if
not avoided, will result in death or serious injury. This
signal word is limited to the most extreme situations.
!
WARNING!
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
!
CAUTION!
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices
NOTE: Indicates a special point of information which
requires your attention.
.
IMPORTANT: Indicates additional information is provid-
ed that is necessary to prevent possible damage to the
equipment only.
Introduction
For your safety and to help in developing a better under-
standing of your equipment we highly recommend that
you read the operator sections of this manual. Reading
these sections not only provides valuable training but
also familiarizes you with helpful information and its lo- cation. The parts sections are for reference only and
don’t require cover to cover reading. After reviewing the
manuals store them in a dry, easily accessible location
for your future reference.
Using this Manual