Great Plains 2025P-16TR30 Assembly Instructions - Manual (Page 2)

Great Plains Mfg., Inc.
2 Baffle Kit
118-255M 02/15/2010
Before You Start
Compatibility
Refer to Figure 2
1.
Verify from the serial number plate that the drill is
compatible with this kit.
Inventory
2. Make sure all parts are present (page 6).
Comprehension
3. Review these instructions. Make sure the installers
understand where each part or assembly is
installed, and what tools are required for the task.
Pre-Assembly Preparation
Tools Required
basic hand tools, including:
• indelible marker
• center-punch
• drill bit:
9 ⁄
32
in (letter size K, or 7.1mm)
Work Location
4. Clean out the main seed boxes. See Operator Man-
ual for instructions. If treated seed has been used,
• disconnect seed tubes at meters,
• wash out the boxes,
• thoroughly rinse the boxes, and
• allow them to dry.
Do this in a suitable location other than where the
installation work is to be performed.
5. Move the drill to a location with:
• a solid surface to prevent tipping,
• adequate illumination, and;
• clear surface beneath for recovery of any falling
or dropped parts - if the surface is not clear, have
a tarp or drop cloth available.
Prepare Drill
6. Install any parking stands and lower the drill.
Figure 2
Serial Number Plate
18307
CAUTION !
Chemical Hazard
This installation requires contact with interior components of
the main seed boxes. If treated seed has ever been used in the
boxes, follow chemical supplier instructions for protective
equipment and cleaning residue from the seed boxes.