Great Plains 4000TM Parts Manual - Manual (Page 63)

Revision Comments Part Description Part No. Ref.
Image No. dwg42842
SPINDLE 3.00 X 15.00 586-814D 1.
GKN OIL SEAL; TCM 30414TA-H 816-761C 2.
GKN BRG CONE 39250 TIMKEN ONLY P752354 3.
GKN BRG CUP, 39412 TIMKEN P702252 4.
HUB STUD 3/4-16X2 9/16 GR5 802-171C 5.
GREASE ZERK STRAIGHT 1/8-27NPT 800-130C 6.
BEARING CUP #LM 501310 822-053C 7.
Includes items 4-7 GKN HUB ASY; 8-BOLT, 10000 LBS 815-440C 8.
NUT HEX FLANGE 3/4-16 GR5 P201630 9.
BEARING CONE #LM 501349 822-048C 10.
HARDENED SPINDLE WASHER 148-404D 11.
NUT HEX SLOTTED 1-14 803-095C 12.
PIN COTTER 7/32 X 2 805-060C 13.
GREASE CAP 3.125 X .28 890-277C 14.
Includes items 1-14 8 BOLT HUB SPINDLE 10,000 ASM 815-437C 15.
CENTER SPINDLE SLEEVE 550-489D 16.
SEAL 2.50IDX3.88ODX.47T 816-574C 17.
BRG CONE 2.17ID JM207049 822-230C 18.
BRG CUP JM207010 822-229C 19.
GREASE ZERK 1/4-28 THD FORMING 800-080C 20.
(shown) WALKING BEAM LH 586-451H 21.
WALKING BEAM RH 586-452H 21.
PIVOT SPINDLE 586-510H 22.
WASHER MACH 2.25 X 1.50 X 10GA 804-063C 23.
NUT HEX SLOTTED 1 1/2-12 PLT 803-239C 24.
PIN COTTER 1/4 X 3 PLT 805-115C 25.
HHCS 3/4-10X5 GR5 802-069C 26.
NUT HEX TOP LOCK 3/4-10 PLT 803-367C 27.
WHEEL 18X14 8-BOLT, 0 OFFSET 814-419C 28.
TIRE - TITAN 440/55R18 814-415C 29.
Includes items 28-29 TIRE/WHEEL ASSY 440/55R18 814-420C 30.
01/16/13 - 63 - 586-288P
Table of Contents Part Number Index
Section 3: Transport
Center Walking Beam, 3500-4000
(Applies to 3500TM, 4000TM only)