Compaq iP-60E - Manual (Page 14)

E-1
Battery Replacement
A Check of the Supplied Items and the Names of the Parts
Operation of the Remote Control
• Please use the remote control within a range of about 7 m from the remote control IR sensor of the projector (located at
both the front and rear) and within an angle of 10 degrees to the left and 10 degrees to the right. Note that this distance
may be shorter depending on battery consumption.
• The remote control will not function when there is an obstacle located between the remote control and the remote control
IR sensor of the projector.
1. Remove the battery compartment cover by
pushing in the claw and lifting the cover up.
2. Install two batteries in the battery compart-
ment, making sure that they are aligned as
indicated by the (+) and (–) marks.
3. Return the battery compartment cover to its
original position.
Handling of the Remote Control
• Do not subject the remote controller to such severe impact as dropping it on the floor. Doing so may
damage it and cause it to cease functioning.
• Keep the remote sensor away from water. Wipe the remote controller immediately if it gets wet.
• Avoid heat or hot water. Remove the dry cells when you are not using the remote controller for a long
period of time.
• Do not mix new and old dry cells, or use different types of dry cells at the same time.
• Do not disassemble or heat batteries, or throw them into a fire.
• Follow your local government's disposal instructions for used dry cells.
• The remote controller may not work when it is used near inverter-driven equipment.
• The remote controller may not work or may work ineffectively when it is used near inverter-driven fluo-
rescent lighting.
• Please handle the remote control with care, since there are some operations available only with it.
CAUTION
NOTE:
• When replacing the batteries, buy AA batteries.
• Ni-Cad batteries or other chargeable batteries cannot be used. Use manganese batteries or alkaline batteries.