Compaq iP-60E - Manual (Page 44)

E-
1
Remove the lamp unit cover
Using a minus screwdriver, loosen the screws of the
lamp unit cover, pull in the direction of the arrow, and
remove the cover.
Maintenance
2
Loosen the mounting screws of the lamp unit
Using a minus screwdriver, loosen the 2 screws of the
lamp unit.
3
Pull out the lamp unit
Hold the handle of the lamp unit and pull it up and out.
4
Install a new lamp unit
 Take the lamp unit and press it into the projector.
 Tighten the 2 mounting screws of the lamp unit.
 Align the 2 tabs located on the lamp unit cover with the
projector and attach from the side of the tabs. Tighten
the mounting screws of the lamp unit cover.
Lamp Unit Replacement Procedure
To prevent burns, wait one hour or longer after
the lamp has been switched off before perform-
ing the following procedure.