Compaq iP-60E - Manual (Page 22)

E-1
Connection of the Power Cable and On/Off Switching
Switch On the Power
1
Connect the power cable
The projector will enter the standby mode
and the ON/STANDBY LED will light in red.
2
The projector is now able to make a projection.
3
Switch on the power of the connected equipment
To wall outlet.
Press the POWER button ( )
Operation with the
Projector
Operation with the
Remote Control
The fan will turn, the lamp will light, and the ON/STANDBY LED will light in
green.
The LAMP/COVER LED will flash in green and then light steadily.
• If the LED lights in red after the POWER button is pressed, projector
trouble is indicated.
→ See Page E-40
• Check that the lens cap has been removed before pressing the POWER
button.
Switch Off the Power
Operation with the
Projector
Operation with the
Remote Control
1
Press and hold the POWER button ( ) for 1 second or longer
"Press POWER button again to turn off" will appear on the projection screen.
2
Press the POWER button ( ) one more time.
The lamp will go off.
• The LAMP/COVER LED flashes green and then goes off after about
60 seconds.
The ON/STANDBY LED lights in resistance.
• When the lamp is off, pressing the POWER button while the LAMP/COVER LED is flashing green will not switch the
lamp on again.
To switch the lamp on again, please press the POWER button again after the ON/STANDBY LED lights in red.
3
Disconnecting the Power Cable
The ON/STANDBY LED on the operation panel will go off.
• Do not disconnect the power cable while the lamp is on or while the ventilation fan is turning.
• Unplug the power plug of the projector from the wall outlet when the projector will not be used for an
extended period.
• When the reinserting the power plug into the outlet soon after having unplugged it, please allow a
fixed time (of about 10 seconds) before doing so.
CAUTION