B&G Zeus2 12 - Manual (Page 14)

Basic operation
Turning the unit on and off
You turn the unit on and off by pressing and holding the Power key.
If the key is released before the shut-down is completed, the power off process is cancelled.
You can also turn the unit off from the System controls dialog. This dialog is activated by a
short press on the Power key, or by swiping down from top of the screen.
Ú Note: The System controls dialog will not display the power off option when the unit is
configured as slave. Refer to details in the Zeus 2 Installation manual.
First time startup
The first time the unit is started and after a master reset the system will run through an
automatic start-up sequence, including language setup and automatic data source selection.
You can select to interrupt this sequence and later configure the system yourself.
Standby mode
In Standby mode, the backlight for screen and keys are turned off to save power. The system
will continue to run in the background.
You select Standby mode from the System controls dialog.
Switch from Standby mode to normal operation by a short press on the Power key.
Display illumination
The display backlighting can be adjusted at any time from the System controls dialog. You
can also cycle the preset backlight levels by short presses on the Power key.
If a ZM monitor is plugged into the HDMI output port on a 9" or 12" unit, an additional icon
will be added to the System controls dialog. Select this icon to control the brightness of the
external monitor.
The night mode option optimizes the color palette for low light conditions.
Ú Note: Details on the chart may be less visible when the Night mode is selected!
Locking the touch screen
You can temporarily lock the touch screen to prevent accidental operation of the system.
This feature is also useful when cleaning the screen while the unit is turned on.
When the touch lock is active you can only operate the unit from the keys.
The touch screen operation is locked from the System controls dialog.
You remove the lock function by a short press on the Power key.
2
14 Basic operation | Zeus2 Operator Manual