B&G Zeus2 12 - Manual (Page 95)

Video
The video function allows you to view videos or camera sources on your Zeus 2 .
Ú Note: The video images will not be shared via the network. You can only view the video on
the unit connected to the video source.
If a FLIR camera is available on the Ethernet network, you can display the video and control
the camera from the Zeus
2 .
For information about how to connect the camera, see the separate Zeus 2 Installation
manual.
The Video panel
A video panel can be set up as a single panel, or as one of the panels on a multiple panel
page.
The video image will be proportionally scaled to fit into the video panel. Area not covered by
the image will be colored black.
Setting up the video panel
Video source
Zeus
2 supports two video input channels. You can select to view one channel only, or to
cycle the image between available video cameras.
The cycle period can be set from 5 to 120 seconds.
Video standard
Zeus
2 supports NTSC and PAL video. The two channels are set up individually. Check the
local video standard or the standard of your cameras.
Adjusting the video image
You can optimize the video display by adjusting the video image settings. The settings are
adjusted individually for each video source. Default for all settings: 50%.
18
Video | Zeus2 Operator Manual 95