Chicago Electric MIG 200 93804 - Manual (Page 12)

For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
Page 12 SKU 93804
TO ROUTE THE WIRE
NOTE: When installing wire of a different size or composition, you will also need to
change wire settings, set the gun polarity, and, possibly, install a gas cylinder. See
pages 15-17.
1. IMPORTANT: Securely hold onto the end of the Welding Wire and keep tension on
it during the following steps. If this is not done the Welding Wire will spring backward,
creating a tangled “bird’s nest” and resulting in wasted wire. (See Figure E.)
2. Hold the Welding Wire securely while you cut enough Wire off the end of the Spool
(4B) to remove all bent and crimped Wire. Make sure the cut end has no burrs or
sharp edges (cut again, if needed). (See Figure E.)
3. Loosen, and lower the Handle (6.1C) on the Wire Feed Assembly. Then, raise the
Lever (4C). (See Figure F.)
SPOOL
(4B)
WELDING WIRE
FIGURE E
FIGURE F
HANDLE
(6.1C)
LEVER
(4C)