Chicago Electric MIG 200 93804 - Manual (Page 27)

For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
Page 27 SKU 93804
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A
REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTA-
TION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO
THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACE-
MENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF RE-
PLACEMENT PARTS THERETO.
REPLACING THE WELDING TORCH LINER
Remove NOZZLE, slip type (1E)
Remove TIP (2E)
1. Remove FITTING (16C)
2.Untwist NUT holding GUIDE (14C)
3. Remove GUN CABLE
4.Remove BLOCK, CABLE with CAP
Remove LINER. (10E)
Without bending, insert a new LINER
Pull LINER out the other end
Cut LINER off 9 mm from head tube.
Install TIP (2E), NOZZLE (1E).
Install BLOCK, CABLE with CAP.
Install GUN.
Twist NUT holding GUIDE.
Install FITTING