BlueAnt M1 Stereo Speakers - Manual (Page 4)

4
C. Low Battery
When the M1 battery is low, the Bluetooth Indicator /
Low Battery Indicator (8) will fl ash red.
D. Charging
1. Connect the charger’s plug into the Charger Port (10) of the
M1, then connect the charger into an external power source.
2. The Charge Indicator (11) will turn to a steady orange
whilst charging. When charging is complete, the Charge
Indicator (11) will turn to a steady green.
E. Turning On and Off
Power On: Press and hold the On/Off/Stop Button (9)
for 1 second. The Bluetooth Indicator (8) will
then turn to a blinking blue.
Power Off: Press and hold the On/Off/Stop Button (9)
for 5 seconds until the Bluetooth Indicator (8)
fl ashes red, the unit will then turn off.
F. Pairing to a Bluetooth Mobile Phone or PC/Laptop
Pair the M1 to your Bluetooth mobile phone or Bluetooth
enabled PC/Laptop to create an audio connection between
the two devices.
Pairing to a Bluetooth Mobile Phone:
Important: Make sure that your Bluetooth mobile phone
supports A2DP* (Advance Audio Distribution Profi
le)
before proceeding.
1. From OFF, press and hold the On/Off/Stop Button (9) for
5 seconds until the Bluetooth Indicator (8) turns to a
blinking red/blue, this indicates that the M1 is now
ready to pair.
2. While the M1 is in pairing mode, access the Bluetooth
menu of your mobile phone. Turn on the Bluetooth
* A2DP (Advanced Audio Distribution Profi le) enables you to stream
stereo sound from an audio source (phone, PC or laptop) to a stereo
speaker or headset via Bluetooth. To create an active connection,
both devices must support this profi le.