Cooper Instruments & Systems DFI 250X Digital Weight Indicator - Manual (Page 11)

CF 146 9 V- Rev. 1.0 - 003R-620-100
GROUP
(GRP)
ITEM
(ITM) SELECT
(SEL)
EDIT
(EDT)
Underline = Defaults
OK
DP Decimal Point Position 000000, 00000.0, 0000.00, 000.000, 00.0000, 0.00000 Accept
CAP Maximum Capacity 000100 to 999999 Default = 003000
<SEL> changes position, <EDT> changes digit. Accept
RES
Resolution(Count-By) 1, 2, 5, 10, 20, 50, 100 Accept
UNITS
Weighed Units none, g, kg, lb, t Accept
HI.RES
Resolution x 10 Mode OFF, ON Accept
BUILD
CABLE 4-Wire or 6-Wire 4, 6 Accept
USE Scale Use INDUST, OIML, NTEP Accept
FILTER Reading Average
(time in seconds) none, 0.2, 0.5, 1.0, 2.0, 3.0, 4.0 Accept
MOTION Motion Detection OFF, 0.5-1.0, 1.0-1.0
Default = 0.5 Graduations per Second Accept
INIT.Z Initial Zero on Startup OFF, ON Accept
Z.TRAC Zero Tracking Sensitivity OFF, SLOW (0.5 grads/sec), FAST (10 grads/sec) Accept
Z.RANGE Zero Operating Range -2_ 2, -1_ 3, -20_20
Default = -2_ 2 (–2% to +2%) Accept
OPTION
Z.BAND
Zero 'Dead' Band <SEL> changes position, <EDT> changes digit.
Default = 0 Accept
ZERO
Zero Calibration Routine
Set between zero and full scale
(Current weight displays) <SEL> key to start. Current weight displays.
Remove all weight.
<SEL>, <EDT> or <OK> starts routine (Z.in P displays).
<ITM> key to exit, <SEL>, <EDT> or <OK> to repeat routine.
SPAN Span Calibration Routine
Set between zero and full scale
(Current weight displays) <SEL> key to start. Current weight displays.
Add test weight.
<SEL> or <OK> to show calibration weight value.
Set correct weight. <SEL> changes position, <EDT> changes digit.
<ITM> or <OK> starts routine (S.in P displays).
<ITM> key to exit, <SEL>, <EDT> or <OK> to re-edit calibration weight and repeat
routine.
ED.LIN
Edit Linearization Points
Set between zero and full scale
L1. - - - Select Linearization point
1 to 5
(L1, L2, L3, L4, L5).
(Approx. % of full scale) <SEL> to step through list of points.
<OK> to change selected point or <ITM> to exit.
After <OK> current weight displays.
Add test weight.
<OK> to enter corrected weight. <SEL> changes position,
<EDT> changes digit.
<OK> starts routine (L.in P displays).
<ITM> key to exit, <OK> to repeat routine.
CAL
CLR.LIN Clear Linearization Points
L1. - - - Select Linearization point
1 to 5 <SEL> to step through list of points.
<OK> to select point to clear or <ITM> to exit.
After <OK> press <ITM> to choose Cont. Y (Yes) or Cont. N (No).