Dell Inspiron 530 - Manual (Page 135)

Removing and Installing Parts
135
6 If you are removing the card permanently, install a filler bracket in the
empty card-slot opening.
NOTE:
Installing filler brackets over empty card-slot openings is necessary to
maintain FCC certification of the computer. The brackets also keep dust and
dirt out of your computer.
7 Replace the card retention bracket, ensuring that:
• The guide clamp is aligned with the guide notch.
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the
alignment guide.
8 Fix the card retention bracket by replacing and tightening the screw.
NOTICE:
To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
9 Replace the computer cover, reconnect the computer and devices to
electrical outlets, and then turn them on.
10 Remove the card’s driver from the operating system.
11 If you removed a sound card:
a Enter system setup (see "System Setup" on page 187), go to Onboard
Devices and select Integrated Audio, and then change the setting to On.
b Connect external audio devices to the audio connectors on the back
panel of the computer. See "Back View of the Computer" on page 19.
12 If you removed an add-in network connector:
a Enter system setup (see "System Setup" on page 187), go to Onboard
Devices and select Integrated NIC, and then change the setting to On.
b Connect the network cable to the integrated connector on the back
panel of the computer. See "Back View of the Computer" on page 19
and "Back Panel Connectors" on page 22.
book.book Page 135 Monday, October 6, 2008 11:28 AM