Dell Inspiron 530 - Manual (Page 148)

148
Removing and Installing Parts
7 Tighten the two screws to secure the floppy drive.
8 Attach the power and data cables to the floppy drive.
9 Connect the other end of the data cable to the connector labeled
"FLOPPY" on the system board (see "Inside View of Your Computer" on
page 109) and route the cable through the clip on the shroud.
NOTE:
The location/connectors may vary depending on your system type. For more
information, see "System Board Components" on page 110.
10 Check all cable connections, and fold cables out of the way to avoid
blocking airflow between the fan and cooling vents.
11 Replace the bezel (see "Replacing the Bezel" on page 137).
1 floppy drive 2 data cable 3 power cable
4 system board
connector 5 custom screws (2) 6 screw holes in the
floppy drive
2
4
3
1
5
6
book.book Page 148 Monday, October 6, 2008 11:28 AM