Setting up the monitor, Attaching the stand, Connecting your monitor – Dell u2410 User Manual
Page 36
Back to Contents Page
Setting Up the Monitor
Dell™ U2410 Flat Panel Monitor
User's Guide
Attaching the Soundbar (optional)
Attaching the Stand
To attach the monitor stand:
1.
Remove the cover and place the monitor on it.
2.
Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3.
Press the stand till it snaps into its place.
Connecting Your Monitor
To connect your monitor to the computer perform the following steps/instructions:
l
Turn off your computer and disconnect the power cable.
l
Connect the USB uplink cable.
l
Connect either the white (digital DVI-D) display connector cable, the blue (analog VGA) display connector cable, or the black DisplayPort cable to the
corresponding video port on the back of your computer. Do not use
all the cables on the same computer. Use all the cables only when they are
connected to different computers with appropriate video systems.
Connecting the White DVI Cable and USB uplink cable
NOTE:
The stand is detached when the monitor is shipped from the factory.
WARNING:
Before you begin any of the procedures in this section, follow the
safety instructions
.
NOTE:
USB uplink cable connection enables USB ports and card reader on the monitor to work.