Dell u2410 - Manual (Page 7)

Monitor Specifications
The following sections give you information about the various power management modes and pin assignments for various connectors for your monitor.
Power Management Modes
If you have VESA's DPMS compliance display card or software installed in your computer, the monitor automatically reduces its power consumption when not in
use. This is referred to as Power Save Mode. If input from keyboard, mouse or other input devices is detected by the computer, the monitor will automatically
"wake up". The following table shows the power consumption and signaling of this automatic power-saving feature:
Activate the computer and wake up the monitor to gain access to the OSD .
Pin Assignments
VGA Connector
3 DisplayPort Connector
4 HDMI Connector
5 DVI Connector-1
6 DVI Connector-2
7 VGA Connector
8 Composite Video Connector
9 Component Video Connectors
10 Audio Out (Support two channel output )
11 USB Upstream Port
12 USB Downstream Port
13
Stand Lock （Use a M3x14 threaded screw to
lock stand, screw not provided）
VESA Modes Horizontal
Sync
Vertical Sync Video Power
Indicator
Power Consumption
Normal operation (with
max luminance, Dell
Soundbar and USB
active) Active Active Active Blue 132 W (Maximum)
Normal operation Active Active Active Blue 75 W (Typical)
Active-off mode Inactive Inactive Blanked Amber Less than 1 W
Switch off - - - Off Less than 1 W
NOTE: This monitor is TCO' 03 power management compatible.
NOTE: Zero power consumption in OFF mode can only be achieved by disconnecting the power cable from the
monitor.
Pin
Number 15-pin Side of the
Connected Signal Cable
1 Video-Red
2 Video-Green
3 Video-Blue
4 GND
5 Self-test
6 GND-R