HONDA 2006 honda pilot - Manual (Page 109)

Turn the dial clockwise to increase
the fan speed and airflow. Turn the
dial counterclockwise to decrease it.
When the indicator in the button is
on, air from the vehicle’s interior is
sent throughout the system again.
When the indicator is off, air is
brought in from the outside of the
vehicle (fresh air mode).
The outside air intakes for the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
The system should be left in fresh
air mode under almost all conditions.
Keeping the system in recirculation
mode, particularly with the A/C off,
can cause the windows to fog up.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to fresh air
mode.
Select the fan speed by pressing the
fan control buttons (
or ).
The fan speed is shown in vertical
bars in the display.
Turning this dial clockwise increases
the temperature of the airflow.
The temperature setting is shown in
the display.
On EX and EX-L models, see page
for information on automatic
climate control and semi-automatic
operation.
This button turns the air
conditioning on and off. On LX
models, the indicator in the button is
on when the A/C is on. On EX and
EX-L models, you will see A/C ON
or A/C OFF in the display.
When you turn the A/C off, the
system cannot regulate the inside
temperature if you set the dial below
the outside air temperature.
Press the RR A/C MANUAL button
to adjust the temperature of the rear
passenger compartment
independently. See page
for
information using the rear A/C unit.
112
113
On LX models
On EX and EX-L models
On EX and EX-L models
On EX and EX-L models
On EX and EX-L models
Fan Control
Recirculation Button
Temperature Control Dial
Air Conditioning (A/C) Button
RR A/C MANUAL Button
Vents, Heating, and A/C
Fe
a
tu
re
s
107