HONDA 2006 honda pilot - Manual (Page 270)

△
The spare tire is stored
underneath the rear cargo area.
Remove the plastic cover on the
cargo area lining to access the
shaft for the spare tire hoist. Put the wheel nut wrench on the
hoist shaft. Turn the wrench
counterclockwise to lower the
spare tire to the ground. Keep
turning the wheel nut wrench to
create slack in the cable.
Remove the bracket from the
spare tire.
Place the jack under the jacking
point nearest the tire you need to
change. It is pointed to by a
mark molded into the underside of
the body. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
resting in the jack notch.
Loosen each wheel nut 1/2 turn
with the wheel nut wrench. 8.
7.
6. 5. 9.
Changing a Flat Tire
268
BRACKET
JACKING POINT WHEEL NUT WRENCH