Maytag GEMINI - Manual (Page 18)

©2000 Maytag Appliances Sales Company
16010107 Section 3. Component Description 3-8
HI-LIMIT THERMOSTAT
The HI-Limit Thermostat is mounted to
range main back. The purpose of this
thermostat is to break line voltage to oven
control in case of a runaway temperature.
Range may be removed from cabinetry for
rear serviceability.
Thermostat Replacement
1. Disconnect the appliance from power
source before servicing.
2. Slide unit out of installation.
3. Remove screws securing main back
shield and remove shield.
4. Remove two (2) screws securing
thermostat to range main back.
5. Disconnect wiring.
6. Replace in reverse order.
OVEN DOOR(S)
Do not place excessive weight on an open
oven door or stand on an opened door as, in
some cases, it could cause the range to tip
over, breakage of the door, or serious injury.
Both the upper and lower oven doors are
removable.
To Remove Lift-Off Door:
Open door to stop position. In stop position
door is open approximately 4”. Grasp door
as illustrated. Lift up evenly until door clears
the hinge arms.
DO NOT USE DOOR HANDLE TO LIFT
DOOR.
To Replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge
arms on the range.
3. Slide the door down onto the hinge
arms until the door is completely
Contacts normally closed
Close Temperature - 250 ± 11ºF
Open Temperature - 300 ± 8ºF
CAUTIONS:
• Do not attempt to open or close door
or operate oven until door is properly
replaced.
• Hinge arms are spring mounted and
will slam shut if accidentally hit.
Never place hand or fingers between
the hinges and the front oven frame.
You could be injured if hinge snaps
back.