Humboldt H-3185B Rapid, Freeze Thaw Cabinet - Manual (Page 11)

11
5.4 Setting Number of Cycles
1) Continuing from section 5.3, while the green display is alternating between
“tEr.S” and “Stby” as in the previous section, push the Mode button again
repeatedly until the green display reads “”rcY.n” (Figure 13). The green
display will alternate between “rcY.n” and the number of cycles desired
minus one (i.e for 36 total cycles, it should display 35).
2) To change the number of cycles, press the up or down arrow button until the
desired number minus one is displayed.
5.5 Setting Power Fail-Resume Options
1) Continuing from section 5.4, while the green display is alternating between
rcY.n” and the set number of cycles as in the previous section, continue
pressing the Mode button until the green display reads “PFrE” (Figure 14).
The display will alternate between “PFrE” and “on”.
2) To change the option, press the up or down arrow button until the option
is displayed.
Note: This setting controls what happens when the power fails during a cycling
operation. The controller is preset to resume the cycling when power returns.
The options are “on” and “OFF”.