Aintenance and care, Replace drive belt – Bissell 15D6e User Manual

Page 11

Advertising
background image

w w w . b i s s e l l . c o m

11

M

aintenance and care

Replace drive belt

1. Unplug the vacuum from electrical

outlet.

2. With rotating floor brush removed from

vacuum cleaner (refer to page 10, steps

1-4 of check rotating floor brush and

drive belt), grasp old drive belt and

remove from motor pulley. Discard the

old drive belt.

3. Place new drive belt over motor pulley

and loop other end over rotating floor

brush in the space between the bristles.

NOTE: It is important that you use

only genuine BISSELL replacement

belts. Generic belts may not meet

the exact specifications required

to keep your vacuum operating

at its peak performance. The use

of unbranded belts could lead to

early failure of the vacuum and

could void your warranty.

4. Pull the rotating floor brush firmly into

position, stretching the drive belt, and

place ends of rotating floor brush

down into the slots on sides as shown.

Alignment of brush ends in slots may be

necessary to fully insert the brush.

5. Turn rotating floor brush by hand sev-

eral times in the direction of motor pul-

ley. If properly installed, drive belt will

center itself on rotating brush crown.

6. Replace brush cover and all five screws.

2

Motor

Pulley

3

4

Advertising